A lot of issues with addresses should now be resolved. In particular, addresses related to "cmb" command, "ch" command (and -slots and/or anything related to the hotbar), and "cnm*" (and associated) command should now work without needing to relog. If you start Speeder after playing for a bit, you may still need to relog initially, but after this, you should be all set.
Height will be taken into account when determining distance from mobs. However, it will only be taken into account if it is greater than the two-dimensional distance (i.e., flat distance) between your character and the mob. This is to avoid situations where you might be directly above a mob, which could incorrectly trigger commands like "cnm*."
The following new command has been added:
- “cnmt[number],[mob type],[distance]” — Very similar to the “cnm” command but only counts mobs of “mob type.” Some mob types are listed here, and you can discern mob types yourself via the -target console command.
- As with the other commands, “cnmt*” can be used to check mobs near the cursor.
These changes require updating Speeder to version 80.
The Diablo IV Speeder guide and download link can only be viewed by active members. If you are already logged in and are an active member, simply refresh the page. If you would like to become a member, the Diablo IV Speeder can be purchased here. If you have specific installation questions, please contact us. Thank you.
